Elenco AM Radio Kit Manuel d'utilisateur télécharger pdf (Page 25)

-24-

PC Board Stand

Insert the PC board into the stand as shown.

IMPORTANT: Before installing the antenna coil, determine if you have a 3 wire coil or a 4 wire coil. Assemble

it to the PC board as shown below. Mount the antenna assembly to the PC board.

Put the tab of the first holder into the right hole and twist the tab 90

Put the tab of the second holder into the left hole and twist the tab 90

Slide the ferrite core through the holders.

Slide the antenna coil through the ferrite core.

Note: If the end of a wire from the antenna should break off, strip the insulation off the end with a hot

soldering iron. Lay the wire down on a hard surface and stroke the wire with your iron. The insulation should

come off very easily. CAUTION: The soldering iron will burn the hard surface that you are working on.

3 Wire Type Antenna

Solder the 3 colored wires to the PC

board.

Wire A (red) to the hole marked “RED”.

Wire B (black) to the hole marked

“BLK”.

Wire C (white) to the hole marked

“WHT”.

4 Wire Type Antenna

Solder the 4 colored wires to the PC board.

Wire A (green) to the hole marked “RED”.

Wire B (red and black twisted together) to the hole marked

“BLK”.

Wire C (white) to the hole marked “WHT”.

Figure K

Tabs

C (white)

B (black)

A (red)

C (white)

A (green)

Twisted Together

Red

Black

A (green)

Red

Black

B Twisted Together

C (white)

Punch out one antenna shim from the front flap of the box.

Insert the cardboard antenna shim between the ferrite core and the

antenna coil. This will temporarily hold the coil in place.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Elenco AM Radio Kit Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets Elenco AM Radio Kit