Elenco Soldering Station Manuel d'utilisateur télécharger pdf (Page 10)

-9-

SWITCH ASSEMBLY

Figure H

Apply the front label to the case as shown in

Figure F.

Solder a 4” white wire to lug #3 as shown in Figure G.

Solder a 4” black wire to lug #1 as shown in Figure G.

Insert the switch into the opening on the front as

shown in Figure H.

Strip the insulation off the black and white line cord

wires to expose 1/2” of bare wire if needed.

Slip the 3/4” dia. shrink tubing over the line cord as

shown in Figure I.

Solder the black line cord wire to the #2 lug as

shown in Figure I. Make sure the tubing is away

from the soldering iron, so it will not shrink.

Slip the shrink tubing over the wires and switch as

shown in Figure J.

Use a heat gun or hair dryer and shrink all of the

tubing into place.

Figure G

4” Black Wire

4” White Wire

Back of Switch

Figure F

Front Label

Switch

Case

Black Line Cord Wire

3/4” Shrink Tubing

Figure I

Shrink Tubing

Heat Gun

Figure J

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Elenco Soldering Station Manuel d'utilisateur Page 10