Elenco Soldering Station Manuel d'utilisateur télécharger pdf (Page 3)

Types of Poor Soldering Connections

1. Insufficient Heat - the solder

will not flow onto the lead

as shown.

2. Insufficient Solder - let the

solder flow over the connection

until it is covered. Use just enough

solder to cover the connection.

3. Excessive Solder - could make

connections that you did not intend

to between adjacent foil areas or

terminals.

-2--9-

OPERATION

• Carefully remove the SL-5 parts from the box.

• Insert the iron holder on either the right or the left side.

• Wet the sponge with preferably distilled or tap water, and then place

it into the tray.

• Set the On/Off switch to the Off position and the control knob at

minimum.

• Plug the soldering iron line cord into the AC receptacle on the back

of the station and place the soldering iron into the iron holder

funnel.

• Plug the line cord of the solder station into a 120-volt, 60Hz AC

receptacle.

• Turn the power switch On and set the temperature control to

maximum.

• We will now tin the tip by applying solder to the tip as it heats up

IT before the tip becomes too hot.

• Set the temperature setting to the temperature desired for

soldering. If you are not going to use the iron immediately, set the

temperature in the park

position.

General Areas of Temperature Settings for 40W Iron

4. Solder Bridges - A solder

bridge occurs when solder

runs between circuit paths and

creates a short circuit. This is

usually caused by using too

much solder. To correct this,

simply drag your soldering iron

across the solder bridge as

shown.

Rosin

Soldering iron positioned

incorrectly.

Solder

Gap

Component Lead

Solder

Soldering Iron

Drag

Foil

Use these settings for

soldering temperature

sensitive components.

Use these settings for

general soldering and

connections that

require more heat.

Park Position

In these settings,

temperatures are too

low for soldering. Set

the station in these

positions when not

using it to reduce

oxidation of the

soldering iron tip.

300

550

750

670

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Elenco Soldering Station Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Elenco Soldering Station